Asko 491289 Instalační manuál stáhnout pdf (Strana 6)

6 7

ASKO provides a 7/8˝ (22 mm) diameter corrugated

drain hose which is connected to the back of the unit to

form a high loop.

NOTE:

Do not use any fittings anywhere in the drain line that

are less than 7/8˝ (22 mm) OD.

The access hole for the drain line should be 1-5/8˝ (41 mm)-

2˝ (50mm) max.

The end of the drain

line is 1/2˝ (12 mm), but

it is adjustable to 7/8˝,

3/4˝, 5/8˝ (22mm, 19 mm, and 16 mm). If the drain

connection is larger than

1/2˝ (12 mm), you can easily cut the drain line to fit the

connection.

The illustrations to the right show three ways to connect

the drain supply line.

THE HIGH LOOP

The high loop is necessary for

proper draining. Therefore, all ASKO

dishwashers have the drain hoses

attached to the drain pump and

fastened to the top back of the unit,

as illustrated. This gives the drain hose an automatic

high loop, which is necessary for proper draining. The

drain hose is fastened at the best high loop height.

To eliminate potential drain problems, simply leave this

hose in place.

DO NOT REMOVE THE HIGH LOOP ATTACHED TO THE

BACK OF THE DISHWASHER!

IMPORTANT THINGS TO REMEMBER:

• Failure to provide the proper drain connection height

(minimum of 20" (508 mm) above the bottom of the

dishwasher base) or a 20˝ (508 mm) high loop will

result in improper drainage, which will damage the

machine.

• No part of the drain hose should be higher than 35"

(889 mm) from the bottom of the dishwasher.

• The drain hose can be extended to a maximum length

of 10 feet (3048 mm). Joints and jointed tubes, if any,

must have a minimum 7/8˝ (22 mm) OD.

• If the drain line is going to be connected to a waste

disposer, be sure to remove the knockout or plug

from the fitting on the disposer before connecting the

drain line.

• Do not use fittings smaller than 7/8˝ (22 mm) OD;

otherwise the water may not drain properly.

When the installation is ready, open the supply valve to

pressurize the fill system. Then check that all connections

are tight and there are no leaks.

THREE WAYS TO INSTALL

DRAIN CONNECTIONS

A) Typical connection to sink plumbing before trap

(high loop drain)

B) Connection to air gap then to the trap

C) Connection to waste disposer with air gap

NOTE:

Don’t forget to remove the knockout or plug from the

disposer fitting.

20″ min.

(508 mm)

24″ min.

(610 mm)

20″ min.

(508 mm)

24″ min.

(610 mm)

20″ min.

(508 mm)

24″ min.

(610 mm)

DRAIN CONNECTIONS

CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM

492183_492185 Install DW Outdoor USA EN Rev 02.indd 6 2016-01-08 11:19:37

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Asko 491289 Instalační manuál Strana 6

Komentáře k této Příručce

Související produkty a manuály pro ne Asko 491289